These really finish off the rear, and can fit any BX. Dunno if anyone wants a set, but let me know if you, do so i can get an idea of numbers,if any. They look really good on P1 16vs too
[/img]
P2 16v tail light surrounds
P2 16v tail light surrounds
hey fellas, as i am restoring my 16v at present, and its poked P2 bumpers, i have molded the P2 exclusive tail light inserts for the bumper.
These really finish off the rear, and can fit any BX. Dunno if anyone wants a set, but let me know if you, do so i can get an idea of numbers,if any. They look really good on P1 16vs too
[/img]
These really finish off the rear, and can fit any BX. Dunno if anyone wants a set, but let me know if you, do so i can get an idea of numbers,if any. They look really good on P1 16vs too
[/img]Would rather be driving ONE 16v,than fixng TWO.
I have made up 4 sets!
one set is for icrc, so three are left...
They are hard urethane-CC60- and will need sanding and painting-they are urethane, so heat them in boiling water, fit them, then take em off and paint em.
For my set i just lined em up in the right spot, marked it, then siliconed them on- for where they are, they dont need screws. Unless you have the holes there already, which is fine, the urethane takes self tappers no problems.
one set is for icrc, so three are left...
They are hard urethane-CC60- and will need sanding and painting-they are urethane, so heat them in boiling water, fit them, then take em off and paint em.
For my set i just lined em up in the right spot, marked it, then siliconed them on- for where they are, they dont need screws. Unless you have the holes there already, which is fine, the urethane takes self tappers no problems.
Would rather be driving ONE 16v,than fixng TWO.